tag:blogger.com,1999:blog-5831246284549306448.post1052625223272069279..comments2024-03-03T14:27:21.832+00:00Comments on Pug Addicts - #1 Peugeot Blog & Article Resource: Guide: Peugeot 306 GTI-6 Thermostat ChangeUnknownnoreply@blogger.comBlogger3125tag:blogger.com,1999:blog-5831246284549306448.post-8493369531386813382014-01-04T17:37:31.770+00:002014-01-04T17:37:31.770+00:00Good point Ray - if anyone is interested the bleed...Good point Ray - if anyone is interested the bleed point on the heater matrix is located on the left hand side of the bulk head. It is advisable to bleed from this point but strangely it's never been required when i've done it (and this included changing a radiator).Adminhttps://www.blogger.com/profile/03947262239664165514noreply@blogger.comtag:blogger.com,1999:blog-5831246284549306448.post-75791926351525968832013-12-13T10:31:14.965+00:002013-12-13T10:31:14.965+00:00You do not mention the bleed point on the heater m...You do not mention the bleed point on the heater matrix pipes on the bulkhead. this is higher than the thermostat bleed point and can trap air. I found this in my 405 when the heater matrix was replaced. (I also have a 306hdi). I think though that once this is bled it should not need to be done again when the thermostat is replaced. Anyway very clear instruction.Raynoreply@blogger.comtag:blogger.com,1999:blog-5831246284549306448.post-64103924838000276032013-11-25T23:32:10.372+00:002013-11-25T23:32:10.372+00:00Great! Very nicely explainedGreat! Very nicely explainedKenhttps://www.blogger.com/profile/06858568430683927147noreply@blogger.com